Table of Contents
Advertisement
CHAPTER 5: CONFIGURING THE BUILT-IN NOTIFICATIONS
NOTE: When using the RJ-45 I/O Dry Contacts, they need to be connected to the unit before they can be configured,
and have to be in the Output direction.
If you click on the Finish and Setup Notification button, this will launch the Link Notification Wizard where you can use
the new action for making a notification.
NOTE: If you've connected an expansion board, you can choose it from the Unit/Expansion selection menu as shown
next.
You'll have the following options for controlling the Dry Contact with the action.
If you choose to cycle the dry contact, you can specify the cycle time.
You'll need to change the RJ-45 I/O Dry Contact sensor to Output direction mode from the Sensors page as shown
next.
Change the Direction from Input to Output and click Save.
FIGURE 5-9. OPTIONS
FIGURE 5-10. SELECT THE DIRECTION
FIGURE 5-11. ADVANCED TAB
1.877.877.2269
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
61
Advertisement
Table of Contents
