Table of Contents
Advertisement
convergence, Christie recommends completing mechanical convergence prior to making electronic
adjustments.
If warping with Christie Twist or Mystique, adjust the convergence mechanically. Do not use the
electronic convergence feature.
1. Before adjusting DMD convergence, ensure the projector has reached a steady operational
state. If switching from a white or bright test pattern to a dark convergence test pattern, or if
warming up the projector after a shutdown, allow 15 minutes for stabilization so the optics can
reach a steady state.
2. Ensure the Convergence Enable option is selected:
a) From the display panel, select MENU > Admin > Service.
b) Enter the service password.
The password is only required for the display panel and not the web user interface.
c) Select Convergence Enable.
3. From the Test Pattern menu, select the E-Convergence test pattern and display it full screen.
Until electronic convergence is completed, the displayed image may appear to be blurred and
difficult to read, especially for white text, due to the mis-convergence of the red, green, and
blue pixels.
4. To enable electronics convergence, select MENU > Admin > Service > Convergence.
5. To show the adjustment locations, select Show Convergence Sprite.
Only one adjustment position can be selected at a time.
6. From the Corner list, select the corner you want to adjust first.
By default the top-left position is selected.
7. To select the color for adjustment, select Color and select the appropriate color from the list.
By default, all three color components (red, green, and blue) are displayed.
It may be helpful to obtain a better view of the position of a particular color component if one
or two of the other colors are deselected.
8. Modify the red, green, and/or blue convergence for the selected sprite both vertically and
horizontally by adjusting the sliders so all three color components are overlapped (sprite is
displayed in white).
You cannot move the selected sprite outside the resolution range.
9. To adjust remaining locations, repeat steps 5 to 7.
10. To apply and store the new settings, select Convergence Enable.
Christie Griffyn Series Installation and Setup Guide
020-103314-08 Rev. 1 (06-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
48
Advertisement
Table of Contents
