Figure 2.1 Installing The Din-Rail Mounting Kit; Figure 2.2 Correctly Installed Din Rail Kit - Advantech EKI-7720 Series User Manual

2.3.1.1 Installing the DIN-Rail Mounting Kit
1. Position the rear panel of the switch directly in front of the DIN rail, making sure
that the top of the DIN rail clip hooks over the top of the DIN rail, as shown in the
following illustration.
Warning! Do not install the DIN rail under or in front of the spring mechanism on
the DIN rail clip to prevent damage to the DIN rail clip or the DIN rail.
Make sure the DIN rail is inserted behind the spring mechanism.
2. Once the DIN rail is seated correctly in the DIN rail clip, press the front of the
switch to rotate the switch down and into the release tab on the DIN rail clip.
If seated correctly, the bottom of the DIN rail should be fully inserted in the
release tab.
See the following figure for an illustration of a completed DIN installation proce-
dure.
3. Grasp the bottom of the switch and slightly rotate it upwards. If there is resis-
tance, the switch is correctly installed. Otherwise, re-attempt the installation pro-
cess from the beginning.
EKI-7720 Series User Manual

Figure 2.1 Installing the DIN-Rail Mounting Kit

Figure 2.2 Correctly Installed DIN Rail Kit

9
DIN rail clip
DIN rail
DIN rail clip
release tab