Removing Sfp Modules; Figure 2.9 Attaching A Fiber Optic Cable To A Transceiver; Figure 2.10 Removing A Fiber Optic Cable To A Transceiver; Figure 2.11 Removing An Sfp Transceiver - Advantech EKI-7720 Series User Manual

7. Insert the fiber cable into the transceiver. The connector snaps into place and
locks.

Figure 2.9 Attaching a Fiber Optic Cable to a Transceiver

8. Repeat the previous procedures to install any additional SFP transceivers in the
switch.
The fiber port is now setup.
2.4.2

Removing SFP Modules

To disconnect an LC connector, use the following guidelines:
1. Press down and hold the locking clips on the upper side of the optic cable.
2. Pull the optic cable out to release it from the transceiver.

Figure 2.10 Removing a Fiber Optic Cable to a Transceiver

3. Hold the handle on the transceiver and pull the transceiver out of the slot.
Note! Replace the dust plug on the slot if you are not installing a transceiver.
The dust plug protects hardware from dust contamination.

Figure 2.11 Removing an SFP Transceiver

14
Handle
EKI-7720 Series User Manual