Attach Safety Light Grids Using C-Brackets - Pilz PSEN op2H-SL Series Manual

PSEN op2H-SL Series
Legend
[1] Transmitter
[2] Receiver
[3] Connection cable
The distance between the transmitter and receiver must be within the operating range
}
of the safety light grid used (see

Attach safety light grids using C-brackets

For protected field heights up to 600 mm use 2 C-brackets; with protected field heights >
600 mm we recommend 3 C-brackets. Install the third C-bracket in the same way, in the
middle between the 2 C-brackets as additional support.
1. Make two drill holes in the mounting surface as shown [1] and install the C-brackets [4].
Tighten the M4 screws to 1,2 Nm.
2. Slightly loosen the M3 screw [3] and open the clamping jaws of both C brackets.
3. At a slight angle, insert the transmitter/receiver into the C-brackets at the non-connec-
tion end [4]. Use the corresponding longitudinal slot on the profile.
4. Turn the transmitter/receiver until the transmitter/receiver lock into position in the C-
bracket at the non-connection end.
5. Tighten the M4 screws to 1,2 Nm.
Operating Manual PSEN op2H-SL Series
1004304-EN-01
[1] [2]
[3]
[3]
True
Technical details [
[3]
[1] [2]
[3]
False
43]).
22