Alignment; Alignment Options Depend On The Installation Type; Orientation; Safety Light Grid Alignment - Pilz PSEN op2H-SL Series Manual

PSEN op2H-SL Series

Alignment

Alignment options depend on the installation type

The options for alignment (moving horizontally or vertically, rotating, tilting) depend on the
type of bracket used for fastening and on the base to which the safety light grid is fastened
(strut profile or smooth surface).
Bracket
C-bracket
O-bracket
L-bracket

Orientation

For the safety light grid to function properly, the transmitter and receiver must be correctly
aligned.

Safety light grid alignment

1. Activate alignment mode. Pin 2 and Pin 5 on the transmitter must be unconnected (see
Connector pin assignment [
2. Make sure that the transmitter and receiver are at the same height.
3. Make sure that the receiver is in a stable position.
4. Use horizontal movement, vertical movement and rotation to align the transmitter so
that this LED on the receiver lights up yellow:
5. Rotate the transmitter at the connection end around the optical axis until this LED on
the receiver flashes green:
6. Restrict the area within which this LED flashes green:
By making changes to the transmitter and then the receiver. Align both units in the
middle of this area, so that these two LEDs light up yellow:
Operating Manual PSEN op2H-SL Series
1004304-EN-01
Smooth surface (e.g. wall)
Vertical: Loosen the clamping jaws
on both brackets and move within
the brackets
Horizontal: Remove safety light grid
from bracket, loosen the brackets on
the base and move within the slot
Vertical: Remove the safety light
grid and brackets completely and
drill new holes
Horizontal: Loosen the brackets on
the base and move within the slot
Vertical: Remove the safety light
grid and brackets completely and
drill new holes
Horizontal: Remove safety light grid
from bracket, loosen the brackets on
the base and move within the slot
30]).
OSSD
Base
Strut profile
Vertical: Loosen the clamping jaws on
both brackets and move within the
brackets
Horizontal: Move within the slot, but
only before the safety light grid is
mounted on the brackets
Vertical: Loosen both brackets on the
profile and move within the profile
Horizontal: Loosen the brackets on
the profile and move within the slot
Vertical: Loosen both brackets on the
profile and move within the profile
Horizontal: Loosen the brackets on
the profile and move within the slot
.
1
.
OSSD
.
, .
1 2
34