Table of Contents
Advertisement
References
PM950X-Only Features
Changing System Speed in Normal Mode
1. Link the PM950X with a BC9xxx Base.
2. With the PM950X, read a Compatible Mode programming label on
3. Place the PM950X into the BC9xxx.
The Reader and Base will now be linked at the new programmed speed.
This feature can also be programmed using Datalogic Aladdin.
1. On the BC9xxx Base, change the Compatible mode parameter to low,
2. Place an unlinked PM950X onto the BC9xxx base.
The Reader and base will link with the new programmed speed.
Bluetooth-Only Features
Bluetooth Pin Code
This option specifies the 4-character or 16-character pin code to be used
for authentication of the Bluetooth
1.
2.
3. Determine the desired characters. For example, D254 or
4. Convert the characters to hexadecimal using the
5. Go to
6. Scan the appropriate alphanumeric characters from the keypad in
304
page 238
to set low, intermediate, or high speed.
intermediate, or high speed through Aladdin.
Scan the
ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
ming Mode, then enable
Specify the desired pin code length (4 or 16) by scanning the appropri-
ate bar code in
"Select PIN Code Length"
STOR12345678135M.
inside back cover of this manual.
page 224
and Scan the bar code: SET 4 CHAR PIN CODE or SET
16-CHAR PIN CODE.
Appendix D,
Keypad, representing the hexadecimal entries determined
in the steps above. You will hear a two-beep indication after the last
character.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
link.
To set the pin code:
"Bluetooth Security Mode"
on page 224.
PowerScan™ PD953X/PBT950X/PM950X
on page
224.
ASCII Chart
on the
Advertisement
Table of Contents
