Table of Contents
Advertisement
RS-232 Parameters
NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK
character. ASCII characters or any hex value from 0 to 0xFF can be selected.
To set this feature:
1. Determine the desired character or value.
2. Use the
3. Go to
4. Scan the bar code: SELECT NAK CHARACTER SETTING.
5. Scan the appropriate two alphanumeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-
This completes the procedure. See
set this feature.
Table 30. NAK Character Setting Examples
STEP
ACTION
1
Desired Character/Value
Hex equivalent from ASCII
2
Chart
3
Scan ENTER/EXIT PROGRAMMING MODE
4
Scan SELECT NAK CHARACTER SETTING
Scan Two Characters From
5
Appendix D, Keypad
6
Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
Setting to previously defined characters such as XON, XOFF, or
host commands conflicts with normal operation of these char-
acters. 8-bit data is not recognized when the option
has been set as 7 Data Bits.
ASCII Chart
on the inside back cover of this manual to find the
hex equivalent for the desired character/value.
page 33
and scan the ENTER/EXIT PROGRAMMING MODE bar code
to enter Programming Mode.
Appendix D,
Keypad, that represent the desired character/value in step
1 above. The second character will cause a two-beep indication.
ming Mode.
EXAMPLES
NAK
0x15
'1' and '5'
Table 30
for some examples of how to
$
@
0x24
0x40
'2' and '4'
'4' and '0'
Data Bits
>
0x3E
'3' AND 'E'
273
Advertisement
Table of Contents
