Table of Contents
Advertisement
Getting Started With the ADS1x48EVM
2 Getting Started With the ADS1x48EVM
The following list of steps provides an overview to quickly get the ADS1x48EVM setup and operational. The
subsequent sections in this document expand on each step in order to explain in detail the available features on
the ADS1x48EVM and the corresponding GUI. Links are provided to navigate from this quick-start guide to the
appropriate section at each step, where applicable.
1. Remove the ADS1x48EVM, PAMBoard, and USB cable from the ADS1x48EVM box.
2. If necessary, connect the ADS1x48EVM to the PAMBoard as shown in the left image in
3. Set the ADS1x48EVM jumpers to the desired location:
a.
Power
b.
Clock
c.
RTD connections
4. Connect the micro-USB-to-USB cable from the PAMBoard directly to a USB port on the computer. Do not
connect the cable through a USB hub.
5. Open up the web-based GUI available on the EVM landing page
PDK).
a. First-time users may be
Chrome
™
and the TI Cloud Agent Application. Installing the TI Cloud Agent is a one-time download
and installation.
6. Refresh the GUI such that a green signal displays and the Hardware Connected indicator shows in the
bottom status ribbon (see
7. Select the desired
ADC reference
8.
Connect your sensors or signals
9.
Capture and analyze data
Figure 2-1. Connecting the ADS1x48EVM to the PAMB Board
6
ADS1x48EVM Evaluation Module
(if applicable)
prompted to download and install
Figure
4-2).
voltage.
to the input terminal blocks (J5 and J6).
using the GUI.
Copyright © 2022 Texas Instruments Incorporated
Figure
(ADS1148EVM-PDK
or
the browser extension for Firefox
SBAU378A – SEPTEMBER 2021 – REVISED JANUARY 2022
www.ti.com
2-1.
ADS1248EVM-
™
or
Submit Document Feedback
Advertisement
Table of Contents
