Getting Started With The Ads1263Evm - Texas Instruments ADS1263EVM-PDK User Manual

Getting Started With the ADS1263EVM

2 Getting Started With the ADS1263EVM
The following list of instructions provides an overview to quickly get the ADS1263EVM set up and operational.
The subsequent sections in this document expand on each step to explain in detail the available features on the
EVM and the corresponding GUI. Links are provided to navigate from this quick-start guide to the appropriate
sections at each applicable step.
1. Remove the ADS1263EVM, PHI board, and USB cable from the ADS1263EVM-PDK box.
2. If necessary, connect the PHI to the ADS1263EVM (see
3. Configure the ADS1263EVM:
a. Power supplies (see
b. Clocking (see Section
c. Voltage reference (see
4. Connect the micro-USB-to-USB cable from the PHI directly to a USB port on the computer. Do not connect
the cable to the computer through a USB hub.
5. Open the latest version of the ADS1263EVM GUI on the connected computer:
a. First-time users must download the latest version of the EVM GUI installer from the Tools and Software
folder of the ADS1263EVM
computer.
6. Connect your sensors or signals (see
7. Capture and analyze data (see
4 ADS1263EVM-PDK Evaluation Module
Section 5).
3.3), if applicable.
Section 3.4), if applicable.
and run the GUI installer to install the EVM GUI software on the host
Section 3.1.2) to the input terminal blocks (J3-J6).
Section 7) using the GUI.
Copyright © 2023 Texas Instruments Incorporated
Figure 7-1).
SBAU206B – APRIL 2015 – REVISED MAY 2023
www.ti.com
Submit Document Feedback