Changing Configuration Settings - IBM Adaptec Ultra320 SCSI User Manual

IBM Ultra320 SCSI Controller 2 User's Guide
All Disks—All removable-media drives supported by the
BIOS are treated as hard disk drives. This setting has no
effect on drives under NetWare because NetWare
automatically supports removable-media drives as hard
disk drives.
Note: The Boot Only and All Disks options are available
only if the SCSI Controller BIOS option is enabled.
BIOS Support for Bootable CD-ROM—(Default: Enabled)
When set to Enabled, the SCSI card BIOS allows the computer
to boot from a CD-ROM drive. If booting from a hard disk or
other device, make sure no bootable CD is inserted, or disable
this option.

Changing Configuration Settings

The factory default settings for Adaptec SCSI cards are correct for
most computers. However, if you need to change the settings for
the SCSI card or a SCSI device:
1 If you have not yet installed the SCSI card and the SCSI devices,
do so now. Refer to your SCSI card Installation Guide for details.
2 Start SCSISelect. See
SCSISelect detects all Adaptec SCSI cards and displays the
model number, channel letter, slot number, and PCI address for
each card and channel. Channels are listed separately.
3 Select a channel and press Enter.
Adaptec
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit ( * =default)
3-10
Starting SCSISelect on page
SCSISelect(TM)
29320ALP A at slot 6, 00:0E:00
3-3.
Utility v4.10.0