IBM Adaptec Ultra320 SCSI User Manual page 62

4 The Options menu appears. Select Configure/View SCSI
Controller Settings. (For details on
page 3-15.)
Adaptec
Would you like to configure the SCSI controller, configure
HostRAID settings, or run the SCSI disk utilities? Select
the option and press <Enter>.
<Arrows> move cursor, <Enter> accept option, <Esc> exit (*=default)
The Configuration menu appears. The Configuration menu
displays the current settings for the SCSI bus interface. The BIOS
Information section at the bottom of the menu displays the
Interrupt (IRQ) channel and I/O Port Address of the selected
device. This section cannot be modified.
Note: Text displayed in yellow is for information only and
cannot be selected.
Configuration
SCSI Bus Interface Definitions
SCSI Controller ID .................................................
SCSI Controller Parity ..........................................
SCSI Controller Termination .................................
Additional Options
Boot Device Configuration......................................
SCSI Device Configuration ..............................
Advanced Configuration Options .....................
BIOS Information
Interrupt (IRQ) Channel.................................10
I/O Port Address............................................FC00h, F000h
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit ( * =default)
Configuring the Adaptec SCSI Card 29320ALP with SCSISelect
SCSISelect(TM)
29320ALP A at slot 6, 00:0E:00
Options
Configure/View SCSI Controller Settings
Configure/View HostRAID Settings
SCSI Disk Utilities
Disable HostRAID Support
Adaptec SCSISelect(TM)
29320ALP at slot 6, 00:0E:00
<F6> - Reset to SCSI Controller Defaults
Using SCSI Disk
Utility v4.10
Utility v4.10.0
7
Enabled
Enabled
Press <Enter>
Press <Enter>
Press <Enter>
Utilities, see
3-11