IBM Adaptec Ultra320 SCSI User Manual page 112

IBM Ultra320 SCSI Controller 2 User's Guide
If you are performing a first time UnixWare/Open Unix
installation, see
Unix on page 8-2. If UnixWare/Open Unix is already installed in
your system, see
Already Installed on page
Installing the Driver When Installing UnixWare/
Open Unix
To install the
adpu320
UnixWare/Open Unix:
1 Insert the Install CD of the UnixWare/Open Unix package into
the boot CD-ROM drive. Start your computer.
Wait for the first UnixWare/Open Unix installation screen and
prompt to appear, then follow the on-screen instructions.
2 When prompted to either Install Host Bus Adapter Drivers or
Continue Installation, select Install Host Bus Adapter Driver
and press Enter.
3 Insert the Ultra320 FMS driver disk for UnixWare/Open Unix
into the primary floppy disk drive and press Enter (you cannot
load drivers from a secondary floppy disk drive).
As the driver loads, a message identifying the installed host
adapter briefly appears on screen. The installation process
determines which device drivers on the disks are needed.
4 If you have additional HBA disks, insert the next HBA disk,
select Install Another HBA Disk, and press Enter.
If all of your HBA disks have been installed, remove the last
HBA disk, select Continue Installation, and press Enter.
5 If necessary, enter the DCU (Device Configuration Utility) to
view/change the UnixWare/Open Unix device driver
configuration data.
8-2
Installing the Driver When Installing UnixWare/Open
Installing the Driver When UnixWare/Open Unix is
8-3.
driver at the same time you install