Starting Scsiselect; Exiting Scsiselect - IBM Adaptec Ultra320 SCSI User Manual

SCSISelect Options
Post Display Mode
SCSI Controller INT 13 Support
Domain Validation
Support Removable Disks Under
INT 13 as Fixed Disks
BIOS Support for Bootable CD-ROM
1
Setting is valid only if Multiple LUN Support is enabled.
2
Settings are valid only if host adapter BIOS is enabled.

Starting SCSISelect

To start SCSISelect:
1 Turn on or restart your computer.
During the startup process, pay careful attention to the
messages that appear on your screen.
2 When the following message appears on your screen, press the
Ctrl-A keys simultaneously (this message appears for only a
few seconds):
Press <Ctrl><A> for SCSISelect (TM) Utility!
3 From the menu that appears, use the arrow keys to move the
cursor to the option you want to select, then press Enter.

Exiting SCSISelect

To exit SCSISelect:
1 Press Esc until a message prompts you to exit (if you changed
any settings, you are prompted to save the changes before you
exit).
2 At the prompt, select Yes to exit, then press any key to restart
the computer. Any changes you made in SCSISelect take effect
after the computer restarts.
Configuring the Adaptec SCSI Card 29320ALP with SCSISelect
2
Available Settings
Verbose, Silent,
Diagnostic
Enabled
Disabled: Scan Bus
Disabled: Not Scan
Enabled, Disabled Enabled
Disabled,
Boot Only,
All Disks
2 Enabled, Disabled Enabled
Default Setting
Verbose
Enabled
Disabled
3-3