IBM Adaptec Ultra320 SCSI User Manual page 125

IBM Ultra320 SCSI Controller 2 User's Guide
Installing the Device Drivers for Red Hat Linux
To install the device drivers for Red Hat Linux 7.x and Red Hat
Advanced Server 2.1:
1 Boot off of the Red Hat Linux 7.x CD. Refer to the instructions
for your operating system. Follow the standard installation
steps with the exceptions noted below.
2 At the boot prompt, type: linux dd
You will have about 10 seconds to type the command;
otherwise, you will go directly to the standard installation
screen and you will not be able to use the driver diskette.
3 When the Do You Have a Driver Diskette screen appears, select
Yes and follow the on-screen instructions. Use the diskette
created in x-ref.
Note: If you are installing Red Hat 7.3 or Red Hat
Advanced Server 2.1, continue with normal installation. If
you are installing Red Hat 7.2, continue with Step 4.
4 When the Boot Loader Configuration menu appears, select Use
GRUB as the Boot Loader.
5 When the Boot Disk Creation menu appears, select Skip Boot
Disk Creation.
Note: If you do not select this option, you will copy over
the driver disk and you will not be able to complete the
final steps.
Note: If you are installing Red Hat 7.2 , continue with
normal installation. If you are installing Red Hat 7.3 or
Red Hat Advanced Server 2.1, go to Step 11.
6 At the Congratulations screen, press Crl+Alt+F2.
7 At the prompt, type: chroot /mnt/sysimage
8 Type: mount /dev/fd0 /mnt
9-2