Loading The Driver At Server Bootup - IBM Adaptec Ultra320 SCSI User Manual

3 If necessary, modify the load command line in the
so that the proper path to the driver and all appropriate
command line options are specified. See
Server Bootup on page
The correct syntax to load the Ultra320 driver is:
load [pathname]adpu320 [options]
Command line options are not case sensitive. Placing commas
between command line options is optional. See
Driver at Server Bootup on page 7-5

Loading the Driver at Server Bootup

To automatically load the
file (usually located in your server's startup directory)
startup.ncf
must contain a load command line that specifies the location of the
driver and any appropriate command line options (see
Load Command Line Options on page
information on the
documentation.
The correct syntax to load the driver is:
load [pathname]adpu320.ham [options]
For example, the command line to load the driver from the
directory, with the
c:\nwserver
load c:\nwserver\adpu320 verbose=y
Command line options are not case sensitive. Placing commas
between command line options is optional. See
Command Line Options on page 7-6
To modify the
startup.ncf
Note: You can also use your DOS text editor to modify the
startup.ncf
If you are using NetWare 4.2, type load install at the
NetWare prompt and press Enter.
If you are using NetWare 5.x or 6.0, type load nwconfig and
press Enter.
7-5.
adpu320.ham
file, refer to your NetWare
startup.ncf
verbose=
file:
file.
Installing Novell NetWare
Loading the Driver at
for possible values.
at server bootup, the
7-6). For additional
option on is:
Using the Load
for possible values.
file
startup.ncf
Loading the
Using the
7-5