Table of Contents
Advertisement
References
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state
once the state is entered. The range for this setting is from 1 to 255 seconds in
1-second increments.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the result with leading zeroes to yield three digits. For example: 0 =
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
4. Scan the bar code: SELECT SCANNING ACTIVE TIME SETTING on
5. Scan the appropriate three digits from the keypad in
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See the table below for examples of how to set
this feature.
Table 18. Scanning Active Time Setting Examples
STEP
ACTION
1
Desired Setting
2
Pad leading zero(es)
3
Scan ENTER/EXIT PROGRAMMING MODE
4
Scan SELECT SCANNING ACTIVE TIME SETTING
Scan Three Characters From
5
Appendix D, Keypad
6
Scan ENTER/EXIT PROGRAMMING MODE
242
000, 5 = 005, 20 = 020, etc.
ming Mode.
that represent the duration which was determined in the steps above. You
will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
Mode.
EXAMPLES
1 Second
001
'0', '0' and '1'
90 Sec. (1.5 min.) 180 Sec. (3 min.)
090
180
'0', '9' and '0'
'1', '8' and '0'
page
82.
Appendix D, Keypad
255 Seconds (4.25
min.)
255
'2', '5' and '5'
Heron™ HD3130
Advertisement
Table of Contents
