Interface Selection; Configuring The Interface - Datalogic Heron HD3100 Product Reference Manual

Interface Selection

Upon completing the physical connection between the scanner and its host,
proceed directly to
programming for the interface type the scanner is connected to (for example:
RS-232, Keyboard Wedge, USB, etc.) and scan the appropriate bar code in that
section to select your system's correct interface type.
The scanner, depending upon the model, will support one of the following sets
of host interfaces:
USB Models (2.0 full speed)
• USB-KBD
• USB-COM STD
• USB-OEM
• USB-KBD-ALT
RS-232 / Keyboard Wedge Models
• RS-232 (Standard, Wincor-Nixdorf, OPOS)
• Keyboard Wedge

Configuring the Interface

Scan the programming bar code from the following section which selects the
appropriate interface type to match the system the scanner will be connected
to. Next, proceed to the corresponding chapter in this manual (also listed in the
table) to configure any desired settings and features associated with that inter-
face.
Product Reference Guide
"Configuring the Interface"
Unlike some other programming features and options, interface selec-
tions require that you scan only one programming bar code label. DO NOT
scan an ENTER/EXIT bar code prior to scanning an interface selection bar
code.
NOTE
Some interfaces require the scanner to start in the disabled state when
powered up. If additional scanner configuration is desired while in this
state, pull the trigger and hold it for five seconds. The scanner will change
to a state that allows programming with bar codes.
Interface Selection
on page 11 for information and
11