Rgb Auto Delay - Datalogic Heron HD3100 Product Reference Manual

Reading Parameters

RGB Auto Delay

Specifies the delay time for running the RGB auto mode after the scanner has
gone into an idle state (no label reading, label programming or communication
with Host). The value 0x00 means Auto Mode is disabled. See
Time"
Set RGB Auto Delay
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
on page 240 for more information.
$CRBID
04 = 2 seconds Auto Delay
DEFAULT
Enter/Exit Programming Mode
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
representing your desired character(s). End by scanning
the ENTER/EXIT bar code again.
CANCEL
"RGB Auto Delay
Appendix D, Keypad
~
79