Using As A Hands-Free Stand - Datalogic Heron HD3100 Product Reference Manual

5. Set the stand in place on the screws by aligning the large holes (circled in
blue) with the screw heads.
6. Rotate the stand counterclockwise until you feel it lock into place.
7. If the rotation is obstructed, or if the stand does not lock into place,
remove the stand and adjust the height of the screws. Retry.
8. To remove the stand, rotate clockwise and lift to detach.
Insertion Into Stand
Place the reader into the stand, taking care to insert the handle into the stand
clip as shown.
Correct insertion will be signaled by a beep; then, the reader will be ready to
read bar codes.

Using as a Hands-Free Stand

The Heron HD3130 Stand can be used as a hands-free stand.
Once the reader is correctly inserted into the stand, it is immediately ready to
automatically read any code present in its reading area without pressing the
trigger. A green aiming light is continuously emitted to facilitate the position-
ing of the bar code to be read. Adjust the stand position as needed, as shown in
the following section.
Product Reference Guide
Setting Up the Scanner
9