Table of Contents
Advertisement
Enter/Exit Programming Mode
RGB Good Read Falling Time
Specifies the time for the RGB good read to change the status from the Bright-
ness state to the Off state.
See
"RGB Good Read Raising/Falling Time"
ming instructions.
Set RGB Good Read Falling Time
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
RGB Good Read Holding Time
Specifies how long the RGB good read will stay in Brightness state. See
Good Read Holding Time"
$CRBHT
Set RGB Good Read Holding Time
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
78
$CRBFT
14 = 20 seconds Falling Time
DEFAULT
on page 239 for more information.
14 = 20 seconds Holding Time
DEFAULT
on page 238 for more detailed program-
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
representing your desired character(s). End by scanning
the ENTER/EXIT bar code again.
CANCEL
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
representing your desired character(s). End by scanning
the ENTER/EXIT bar code again.
CANCEL
RGB LED Settings
Appendix D, Keypad
~
"RGB
Appendix D, Keypad
~
Heron™ HD3130
Advertisement
Table of Contents
