Table of Contents
Advertisement
Trouble shooting
en
Fitting the door on the appliance
When fitting the intermediate panel, make sure that the
arrow is in the top right of the panel and that it aligns
with the arrow on the metal panel.
Insert the intermediate panel at the bottom into the
1.
retainer and push it in firmly at the top (figure
Push both retainers downwards (figure
2.
Insert the front panel at the bottom into the retainers
3.
(figure
).
#
Close the front panel until both upper hooks are
4.
opposite the opening (figure
Press the front panel at the bottom until it clicks
5.
audibly into place (figure
Open the appliance door again slightly and remove
6.
the tea towel.
Screw both screws back in on the left and right.
7.
Put the cover back in place and press on it until it
8.
clicks audibly into place (figure
Close the appliance door.
9.
Caution!
Do not use the cooking compartment again until the
panels have been correctly fitted.
26
).
!
).
"
).
$
).
%
).
&
3Trouble shooting
I f a fault occurs, there is often a simple explanation.
T r o u b l e s h o o t i n g
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Rectifying faults yourself
You can often easily rectify technical faults with the
appliance yourself.
If a dish does not turn out exactly as you wanted, you
can find useful cooking tips and instructions at the end
of this instruction manual. ~ "Tested for you in our
cooking studio" on page 40
Fault
Possible
cause
The appliance is
Defective cir-
not working.
cuit breaker.
Power failure Check whether the kitchen light or
The time is flash-
Power fail-
ing on the dis-
ure.
play.
The settings on
The child-
the appliance
proof lock is
cannot be con-
activated.
figured. A key
symbol has lit up
on the display or
†'"".
The appliance
The appli-
door will not
ance door is
open. A key sym-
locked with
bol has lit up on
the child-
the display.
proof lock.
The appliance
The appli-
door will not
ance door is
open. A lock
locked by
symbol H has lit
the cleaning
up on the dis-
function.
play.
After an operat-
The appli-
ing mode is
ance has not
switched on, œ
cooled down
is flashing on the
sufficiently.
display.
The appliance is
Demo mode
not heating. Two
is active.
dots are flash-
ing on the dis-
play panel. On
some appli-
ances, š will
also appear on
the display
panel.
--------
Notes/remedy
Check the circuit breaker in the
fuse box.
other kitchen appliances are work-
ing.
Reset the time.
Deactivate the childproof lock by
pressing and holding the button
with the key symbol for approx. 4
seconds.
Deactivate the childproof lock by
pressing and holding the button
with the key symbol for approx. 4
seconds.
The lock can be switched off in the
basic settings.
Wait until the cooking compartment
has cooled down and the lock
symbol H has gone out.
Switch off the appliance, allow it to
cool down and switch on the oper-
ating mode again.
Briefly disconnect the appliance
from the mains (switch off the cir-
cuit breaker in the fuse box) and
then deactivate demo mode within
approx. 5 minutes. To do this, set
the basic setting ™‚„ or ™' to the
value ‹. ~ "Basic settings"
on page 19
Advertisement
Table of Contents
