Upgrading Mcu Firmware; Operation Using The Infrared Remote Controller; Pan/Tilt And Zoom Operation - Bolin Technology 2 Series User Manual

Upgrading MCU Firmware

MCU Firmware can be upgraded by following these steps:
1. Load the .bin file onto a flash drive (Formatted as FAT32), and name
the file "HD20.bin"
2. With the camera powered off, insert the flash drive to the USB port on
the back panel of the camera
3. Apply power to the camera
The green indicator light above the lens will turn red for a few seconds while
the upgrade takes place. Once the upgrade is finished, the light will turn green,
and the camera will proceed through a normal boot cycle. Check the data on the
OSD boot screen
NOTE:
The firmware upgrade process is intended to be performed under the supervision of a BOLIN-Authorized repair
technician. For assistance with this, please contact your authorized BOLIN Technology dealer, installer, or integrator.
BOLIN Technology Technical Support can also be reached for assistance with this process.

Operation Using the Infrared Remote Controller

Pan/Tilt and Zoom Operation

Panning and Tilting
1. Press the POWER switch.
The camera will turn on and perform the pan/tilt reset operation
automatically.
2. Press the arrow button to pan or tilt the camera.
While checking the picture on the screen, press the desired arrow
button.
To move the camera in short increments, press the button just for
a moment.
To move the camera in long increments, press and hold the
button.
To move the camera diagonally, press the "←, →" button while
holding down the "↑, ↓" button.
Restore to starting position
Press the HOME button.
If the camera moves in a different direction from the one that you intended
The camera is preset so that the image output from the camera is rotated toward the right whenever you press
the "←, →" button.
To face the camera toward the opposite direction
You might wish to face the camera toward the opposite direction from that of the button you pressed, for example, when
you change the direction of the camera while checking the picture on the screen. In such a case, press the 2 (REV) button
while holding down the L/R DIRECTION SET button.
Arrow button Movement of the
camera
Setting
While holding
down
Press
30