Documents Which Also Apply; Warranty; Declaration Of Conformity; Welding In Environments With Increased Electrical Hazards - EWM L2.00 DC Expert 3.0 TIG Operating Instructions Manual

Intended use

Documents which also apply

3.3 Documents which also apply
3.3.1

Warranty

For more information refer to the "Warranty registration" brochure supplied and our information regarding
warranty, maintenance and testing at www.ewm-group.com!
3.3.2

Declaration of Conformity

This product corresponds in its design and construction to the EU directives listed in the decla-
ration. The product comes with a relevant declaration of conformity in the original.
The manufacturer recommends carrying out the safety inspection according to national and in-
ternational standards and guidelines every 12 months.
3.3.3

Welding in environments with increased electrical hazards

Power sources with this marking can be used for welding in an environment with increased elec-
trical hazard (e.g. boilers). For this purpose, appropriate national or international regulations
must be followed. The power source must not be placed in the danger zone!
3.3.4

Service documents (spare parts and circuit diagrams)

No improper repairs and modifications!
To prevent injuries and damage to the machine, only competent personnel (authorised
service personnel) are allowed to repair or modify the machine.
Unauthorised manipulations will invalidate the warranty!
• Instruct competent personnel (authorised service personnel) to repair the machine.
Original copies of the circuit diagrams are enclosed with the unit.
Spare parts can be obtained from the relevant authorised dealer.
3.3.5

Calibration/Validation

An original certificate is enclosed with the product. The manufacturer recommends calibration / validation
at intervals of 12 months.
14
WARNING
099-00L200-EW501
13.05.2022