Intended Use; Applications; Use And Operation Solely With The Following Machines; Documents Which Also Apply - EWM Drive XQ AC Operating Instructions Manual

Intended use

Applications

3 Intended use
Hazards due to improper usage!
The machine has been constructed to the state of the art and any regulations and stand-
ards applicable for use in industry and trade. It may only be used for the welding proce-
dures indicated at the rating plate. Hazards may arise for persons, animals and material
objects if the equipment is not used correctly. No liability is accepted for any damages
arising from improper usage!
• The equipment must only be used in line with its designated purpose and by trained or
expert personnel!
• Do not improperly modify or convert the equipment!
3.1 Applications
Wire feeder to feed wire electrodes for gas-shielded metal-arc welding.
3.2

Use and operation solely with the following machines

A suitable power source (system component) is required in order to operate the wire feed unit!
The following system components can be combined with this machine:
Titan XQ puls
Titan XQ AC puls
Phoenix XQ puls
Taurus XQ Synergic
Taurus XQ Basic
3.3

Documents which also apply

3.3.1

Warranty

For more information refer to the "Warranty registration" brochure supplied and our information regarding
warranty, maintenance and testing at www.ewm-group.com!
3.3.2

Declaration of Conformity

This product corresponds in its design and construction to the EU directives listed in the decla-
ration. The product comes with a relevant declaration of conformity in the original.
The manufacturer recommends carrying out the safety inspection according to national and in-
ternational standards and guidelines every 12 months (from commissioning).
3.3.3

Service documents (spare parts and circuit diagrams)

No improper repairs and modifications!
To prevent injuries and damage to the machine, only competent personnel (authorised
service personnel) are allowed to repair or modify the machine.
Unauthorised manipulations will invalidate the warranty!
• Instruct competent personnel (authorised service personnel) to repair the machine.
Original copies of the circuit diagrams are enclosed with the unit.
Spare parts can be obtained from the relevant authorised dealer.
3.3.4

Calibration/Validation

An original certificate is enclosed with the product. The manufacturer recommends calibration / validation
at intervals of 12 months (from commissioning).
12
WARNING
Drive XQ Drive XQ AC
Drive XQ IC 200
WARNING
Drive XQ Basic
Drive XQ IC Basic 200
099-005613-EW501
05.12.2023