Red Flags On Transmission Information Page; Terminal Status Page; Figure 19: Terminal Status Page (Top Part) - Hughes HN9500 User Manual

System Control Center

Red flags on Transmission Information page

Terminal Status page

If you see a red flag next to Transmit Status on the Transmission Information page, see Transmit
Status in Table 6: Red flags on System Status page
Status in that table also applies to the Transmission Information page.
The Terminal Status page displays information about the operational state of the satellite router
and operational statistics such as messages and packets sent, received, and dropped. It indicates
whether acceleration is enabled and provides a count of traffic that moves across the LAN to
the satellite router.

Figure 19: Terminal Status page (top part)

The operational parameters listed on the Terminal Status page are shown in a tabular format.
The first (left) column identifies the parameter categories:
• Overall Status – Shows the major features such as dial backup or acceleration. (Some listed
features may not be included in your service plan.)
• Transport Interface Receive Statistics – Indicates messages received and decoded by the
satellite router from the satellite.
• Transport Interface Transmit Statistics – Indicates messages being queued up by the satellite
router for transmission to the satellite.
• LAN Interface Statistics – Shows traffic across the LAN interface to the satellite router.
• IP Forwarding and Routing Statistics – These refer to system control messages.
• Local IP Interface Statistics – Sum of various counts of messages.
• Dial Backup Status – Count of dial backup traffic if the VADB feature is enabled. (Some
listed features may not be included in your service plan.)
on page 23. The information for Transmit
HN9500 Satellite Router User Guide
1037737-0001 Revision E
Chapter 2
29