Table of Contents
Advertisement
Chapter 2
Parameter
Receive Path Fault
RX Error
Total Satellite Packets Received
CONUS Packets Received
PTP Packets Received
Unicast Data IP Datagrams
Multicast IP Datagrams
Management and Signaling IP
Datagrams
Satellite Packets Dropped
Frames With No Signal
Number of TIPS Received
Red flags on Reception Information page
Flagged parameter
Receive Status
Receive Signal Strength
HN9500 Satellite Router User Guide
26
1037737-0001 Revision E
Typical values
Traffic Statistics: Receive
A red flag next to a value on the Reception Information page indicates a problem related to the
parameter listed in the same row where the flagged value appears. For explanation, find the
flagged parameter in this table. If a state code is displayed next to the parameter, refer to
12: State codes
on page 35 identify the probable cause and possible solution.
Table 8: Red flags on Reception Information page
Probable cause
Various causes are indicated by
state codes 26–35.
Probing failure (occurs only during
commissioning).
Registration failure (occurs only
during commissioning).
No Beacon (or)
SQF of 0 or 1.
OK
Not applicable (parameter reserved
for future use).
≥ 0
Any whole number.
≥ 0
Any whole number.
≥ 0
Any whole number.
≥ 0
Any whole number.
≥ 0
Any whole number.
≥ 0
Any whole number.
≥ 0
Any whole number.
≥ 0
Any whole number.
≥ 0
Any whole number.
≥ 0
Any whole number.
See
Table 12: State codes
35. Most of these problems must
be corrected by a qualified installer.
There is a problem with the
configured latitude and longitude.
Make sure the entered latitude and
longitude values are correct and in
the correct format. This problem
must be corrected by a qualified
installer.
The problem must be corrected by
a qualified installer.
Make sure the receive cable is
tightly connected to the router's rear
panel. Any other cable connections
must be checked by a qualified
installer.
System Control Center
Range of values
Table
Possible solutions
on page
Advertisement
Table of Contents
Troubleshooting
