Red Flags On System Status Page; Table 6: Red Flags On System Status Page - Hughes HN9500 User Manual

System Control Center
Parameter
Fair Access Policy Threshold
Exceeded
TurboPage TTMP Status
IPsec Status
AGW Attach State

Red flags on System Status page

Flagged parameter
Receive Status (or)
Transmit Status
Typical values
Primary Attached
A red flag next to a value on the System Status page indicates a problem related to the parameter
listed in the same row where the flagged value appears. For explanation, find the flagged
parameter in this table. If a state code is displayed next to the parameter, refer to
page 35 to identify the probable cause and possible solution.

Table 6: Red flags on System Status page

Probable cause
Various causes are indicated by
state codes 26-35.
Probing failure (occurs only during
commissioning).
Registration failure (occurs only
during commissioning).
No Yes – FAP threshold is exceeded,
so transmission is reduced or
disabled for a period of time.
No – FAP threshold has not been
exceeded.
Up Up – TurboPage Server connection
is up (all TTMP connections are up).
Down – TurboPage Server
connection is down (one or more
TTMP connections is down).
Disabled – TurboPage is disabled.
Disabled Up – All configured IPSec sessions
have tunnels established.
Down – None of the configured
IPSec sessions have tunnels
established.
Not all sessions are up – Some of
the configured IPSec sessions have
tunnels established.
Disabled – IPSec is disabled.
Enabled – IPSec is enabled.
Primary
Alternate
Unattached
See
35.
There is a problem with the
configured latitude and longitude.
This problem must be corrected by
a qualified installer.
This problem must be corrected by
a qualified installer.
HN9500 Satellite Router User Guide
Chapter 2
Range of values
State codes
Possible solutions
Table 12: State codes on page
1037737-0001 Revision E
on
23