Figure 30: Terminal Connectivity Test Page; Figure 31: Connectivity Test Results Page - Hughes HN9500 User Manual

Chapter 5
HN9500 Satellite Router User Guide
50
1037737-0001 Revision E

Figure 30: Terminal Connectivity Test page

2. Click Start Test.
You may see a screen that asks you to wait while the test is conducted. When the test finishes,
the Connectivity Test results page appears.

Figure 31: Connectivity Test results page

If the number of messages sent equals the number of messages received, the test is
successful—there is good connectivity between the remote router and the satellite.
If the number of messages received is greater than zero but not equal to the number of
messages sent, you have physical connectivity to the satellite, but if this test result persists,
you may have an access problem.
Typically the delay time (time message is sent until it is received) is approximately 1 second.
The screen shows the minimum, average, and maximum delay times for the test messages
in milliseconds. Most important is whether all messages are received or not.
For additional information, see How to interpret these results on the test results page.
Troubleshooting