Twincat 3 Procedure - Beckhoff EL47 Series Documentation

5.4.1

TwinCAT 3 procedure

From TwinCAT 3.1 build 4012 and using the revision as below specified in the configuration, the integrated
ScopeView recognizes in its variable browser that the oversampling data is an array package and activates
ForceOversampling automatically. The array as a whole must be selected using AddSymbol (see description
in the next section).The extended PDO name provides the basis for this. Since a specific revision of the
respective terminal ScopeView is able to detect the array type of a set of variables autonomous.
Terminal Revision
EL4732 all
EL4712 all
EL3783 EL3783-0000-0017
EL3773 EL3773-0000-0019
EL3751 all
EL3742 all
EL3702 all
EL3632 all
EL2262 all
EL1262-0050 all
EL1262 all
EP3632-0001 all
EPP3632-0001 all
Recording a PLC Variable with the TwinCAT 3 – ScopeView
By a precondition of an already created TwinCAT 3 – project and a connected PLC with an oversampling
able terminal/box within the configuration it will be illustrated how an oversampling variable can be
represented by the Scope (as a standard part of the TwinCAT 3 environment). This will be explained by
means of several steps based on an example project "SCOPE_with_Oversampling" as a standard PLC
project.
Step 1: Adding a project „Scope YT"
The example project "SCOPE_with_Oversampling" has to be added a TwinCAT Measurement – project
"Scope YT project" (C) by right click (A) and selection (B) "Add" → "New Project..". Then "Scope for OS" will
be entered as name. The new project just appears within the solution explorer (D).
EL47xx Version: 2.7
Commissioning
109