Starting To Print; Settings For The Material Type; Printing The Status Report - Novexx Solutions 64 Series User Manual

02/16 Rev. 04

Starting to print

Settings for the material type

The parameter settings described below provide the printer with the necessary infor-
mation about the label material used. When printing from a layout program, these set-
tings are usually provided automatically by the printer driver. For your first test prints,
you need to configure them manually.
Material type
The label material is "endless", which means that it contains no punches/perforations,
breaks or reflex marks that could be recognised by the punch sensor:

The label material contains punches/perforations, breaks or reflex marks that can be
recognised by the punch sensor (so-called "punched" material):

Material length

Material width

Only for punched/perforated material:
Type of punch
Label material with breaks or punches:

Label material with reflex marks:

Setting parameters: see topic section
the Parameter Menu".

Printing the status report

A status report printout is a perfectly adequate printer test. The width of the status
printout can be set to 100 mm or 50 mm. This should match the width of the label ma-
terial used. The length of the printout is 200 mm.
100 mm width

The printout that is triggered spans a label length of 2x 200 mm, listing all of the print-
er's current parameter settings.
50 mm width


The printout that is triggered contains the same information as the wider printout, com-
pressed to a width of 50 mm.
Density
If the printout is not as black as you would like it to be, increase the print density as
follows:
1. Press the Esc button while in online mode. Display:
USER MANUAL
Set the PRINT PARAMETER > Material Type
PRINT PARAMETER > Material Type
Set the
Set the PRINT PARAMETER > Material Length
PRINT PARAMETER > Material Width
Set the
SYSTEM PARAMETER > Sensor Type
Set the
SYSTEM PARAMETER > Sensor Type
Set the
Navigate to INFO PRINTOUT > Printer
Set the SYSTEM PARAMETER > Print Info Mode
INFO PRINTOUT > Printer
Navigate to
Print contrast
60%
64-xx
to "endless".
to "Punched".
to the length of the material (in mm).
to the width of the material (in mm).
to "Punched".
to "Reflex".
Info-Printouts and Parameters
Status.
to "Compact right".
Status.
21
Starting to print
, chapter "Using