Connecting The Base When Security Pin Is Enabled - Datalogic Gryphon Series Product Reference Manual

Configuring the Base Station
Figure 11. Disconnecting the Cable

Connecting the Base when Security Pin is Enabled

When connecting the Base to a system that has a custom Security Pin enabled, follow the steps
below in the order shown:
1. Power down the host system.
2. Connect the appropriate interface cable into the Base
3. Place the reader in the Base.
4. Power up the host. The reader will link to the Base
5. When the host completely powers up, a new custom Security Pin Code may be sent to the
Product Reference Guide
reader and Base, depending on host configuration. Contact Datalogic Technical Support
for more information.
If you want to change security settings or set up a PIN, see
Mode" starting on page
Insert
Paper Clip
as shown in
245.
Setup
.
Figure 10
"BT Security
25