Aiming Duration Time - Datalogic Gryphon Series Product Reference Manual
General purpose handheld area imager bar code reader
Hide thumbs
Also See for Gryphon Series:
- Quick reference manual (33 pages) ,
- Reference manual (20 pages)
Table of Contents
Advertisement
References
Aiming Duration Time
Specifies the frame of time the aiming pointer remains on after decoding a label, when in trigger
single mode. The range for this setting is from 1 to 255 seconds in 1-second increments.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the result with leading zeroes to yield three digits. For example: 0 = 000, 5 = 005, 20
3. Go to
4. Scan the bar code: SELECT AIMING DURATION TIME SETTING.
5. Scan the appropriate three digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See
Table 41. Aiming Duration Time Setting Examples
STEP
ACTION
1
Desired Setting
2
Pad leading zero(es)
3
4
Scan Three Characters From
5
Appendix D, Keypad
6
280
= 020, etc.
page 104
and scan the ENTER/EXIT PROGRAMMING MODE bar code to
enter Programming Mode.
the duration which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
Mode.
1 Second
001
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT AIMING DURATION TIME SETTING
'0' , '0' and '1'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D,
Table 41
for some examples of how to set this feature.
EXAMPLES
90 Sec. (1.5 min.)
180 Sec. (3 min.) 255 Seconds (4.25 min.)
090
'0' , '9' and '0'
'1' , '8' and '0'
Gryphon™ I GD44XX/GBT4400/GM440X
Keypad, that represent
180
255
'2' , '5' and '5'
Advertisement
Table of Contents
