Good Read Led Duration - Datalogic Gryphon Series Product Reference Manual

References

Good Read LED Duration

This feature specifies the amount of time that the Good Read LED remains on following a good
read. The good read LED on time can be set within a range of 10 milliseconds to 2,550
milliseconds (0.001 to 2.55 seconds) in 100ms increments.
Follow these instructions to set this feature:
1. Determine the desired setting in milliseconds. A setting of 0 means that the good read
2. Divide the desired setting by 10 (setting is in 100ms increments). Pad the result with lead-
3. Go to
4. Scan the bar code: SELECT GOOD READ LED DURATION SETTING.
5. Scan the appropriate three digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See
Table 38. Good Read LED Duration Setting Examples
STEP ACTION
1 Desired Setting
Divide by 10 (and pad with
2
leading zeroes)
3
4
Scan Three Characters From
5
Appendix D, Keypad
6
276
LED stays on until the next time the trigger is pulled.
ing zeroes to yield three digits. For example: 0 = 000, 5 = 000, 20 = 020, etc.
page 96 and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter
Programming Mode.
the duration which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
Mode.
Good Read LED
stays on until next
trigger pull (00)
000
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT GOOD READ LED DURATION SETTING
'0' , '0' and '0'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D, Keypad
Table 38 for some examples of how to set this feature.
EXAMPLES
20ms
002
'0' , '0' and '2' '0' , '1' and '5'
Gryphon™ I GD44XX/GBT4400/GM440X
representing
150ms 2550ms (2.55 sec.)
015 255
'2' , '5' and '5'