Table of Contents
Advertisement
To display information from the third-party device on the OSD, you need to select OSD as the port mode. The camera
receives information from the third-party device through the RS485 serial port, translates the received information, and
then displays it on the OSD.
NOTE:
To enable the camera to correctly translate information received from the third-party device, make sure that the
information sent by the third-party device through the serial port complies with the data format specified by our company.
For more details, contact your dealer.
1.
Click Setup > System > Ports & Devices, and then click the Serial
Port tab.
2.
Select OSD from the Port Mode drop-down list and select
Enable OSD Report. Then OSD data will be reported to the
management platform.
3.
Click Save.
Transparent Channel Configuration
Transparent channel is mainly used to achieve transparent data transmission between two devices.
NOTE:
This function is not supported by some models, please see the actual model
for details.
Make sure that you have set Port Mode to Trans-Channel for your camera.
The actual displayed Web interface may vary with the device model.
1.
Click Setup > System > Ports & Devices, and then click the Trans-
Channel tab.
2.
Select Enable for Trans-Channel.
3.
Enter the destination IP address and port number (IP address and
port number that the transparent channel connects to).
4.
Click Save.
Maintenance
41
Advertisement
Table of Contents
