Table of Contents
Advertisement
SAFETY PRECAUTIONS
This shrinking device is only intended for professional use.
Take care to use the correct power supply:
The device only accepts the voltage AC 3 x 400 V (+/-10%) + PE/28 A/50 Hz
For other voltages the use of a ZFM30IN30 transformer is required, which needs to be bought separately:
- Input voltages: 3 x 208 / 240 / 480 / 600 VAC + GND/28 amp/50-60 Hz
- Output voltages: AC 3 x 400 V + PE/28 A/50 Hz
The power supply for the refrigeration unit is: 1 x 230 V + PE/16 A/50-60 Hz.
The Shrinkfit holder becomes very hot during operation. Touching this spot may cause serious burns. Always wear gloves
when handling Shrinkfit holders.
Persons with medical implants are not permitted to use or work with this device. Persons with pacemakers must refer to the
guidelines of their pacemaker established on the basis of: NF EN 60601-1-2 (September 2007).
Repairs to the shrinking devices should only be carried out by skilled operators. Please contact your Seco Sales Unit.
Only trained and authorized persons are permitted to use the shrinking devices.
RECOMMENDATIONS FOR USE AND MAINTENANCE
Always make sure the holder has cooled down prior to shrink grip or shrink release.
The holder and the tool must be clean, free from grease and dry before being fitted to the device.
Before starting the shrinking process, please always check if:
▪
The power supply is sufficient
▪
The length has been set correctly, with the correct stop rod
▪
The correct heat-focusing stopper has been chosen
▪
Recommended cylindrical tool shank tolerance is h5 or h6 (maximum h5 for Ø3 (Ø0.118") to Ø5 mm (Ø0.196"),
maximum h6 for Ø6 (Ø0.236") to Ø32 mm (Ø1.26"))
▪
The tool shank is not damaged
Keep the device and its environment clean to ensure a long service life.
The device can only be used for the purposes defined in this operating manual. Seco Tools Tooling Systems cannot be held
responsible for casualties caused by any other use.
Maintenance is limited to regular cleaning of the device and accessories with adapted products.
SAFETY FUNCTIONS OF THE HEATING MODULE
- The inductor is equipped with a sensor to avoid overheating of the holders and if the temperature limit is reached the
Interface will be not available.
- To increase the service life of the holders, the electronics of the device have been programmed to allow only one main
heating process, which it automatically cuts off after use.
ANNEXES
Technical features
Compliance declaration for heating modules, support and cooling boxes (to fill in)
Certificate
28
Advertisement
Table of Contents
