Shrinkfit - Seco EASYSHRINK EVO User Instructions

SHRINKING PROCESS
1
Choose the tool holder finned support that corresponds to your
tool holder
2
Select the corresponding heating mode to use with help of the
specification located on the flange and the table above
3
Place the finned support on the rotary plate hole
4
Take the heat-focusing stopper corresponding to your tool shank
diameter and place it in the inductor.
Secure the heat-focusing stopper by turning the heat-focusing stopper
a quarter turn into the inductor
NOTE
Only use ZFAT30C06 for special short tool holders. More details on
the "Heating Mode Selection" sticker.
20
1
2
3
4