Seco EASYSHRINK EVO User Instructions page 21

5
Move the inductor housing downwards on the holder by pressing
the button on the handle.
The heat-focusing stopper must be in contact with the top of the tool
holder.
6
Push the Mode button until you reach the corresponding mode
shown earlier in the table.
7
Put the protective glove on, take and hold the cutting
tool using the glove.
8
Push the Heating cycle button once and wait for the heating cycle
LED to go off.
9
Quickly move the inductor housing upwards.
10
Quickly place the tool inside the tool holder and wait for the tool
to be correctly clamped.
11
Turn the rotary plate:
- With a water-cooling system: Place the right contact bushing
and the cooling bell on the tool holder
- Without a water-cooling system: Place the cooling cone
Contact bushing Air cooling cone
5
6
8
11
21