Table of Contents
Advertisement
ACCESSORIES AND SPARE PARTS
Important: These accessories related to the Shrinkfit tool holders must be
ordered separately in order to use the Easyshrink EVO.
REQUIRED AS A MINIMUM FOR SHRINK GRIP AND SHRINK RELEASE
OPERATIONS
▪
Finned supports for each type of machine side taper used on Shrinkfit
tool holders. Available for all types of tool holder (HSK / DIN & DIN TF
/ BT & BT TF / CAT & CAT TF / Capto).
Provides positioning of the tool holder onto the support module.
REQUIRED AS A MINIMUM FOR THE WATER COOLER
▪
Contact bushing for each type and size of Shrinkfit tool holder used.
Available for all types of Shrinkfit holders and diameters (DIN type /
Reinforced / Mold and Die / MQL)
Required to extract heat from the front end of the holder towards
the liquid cooling bell.
SPARE PARTS
▪
Set of standard and thin stop rods.
4 stop rods with 2.5 mm (0.098") front end and 4 stop rods with 5 mm
(0.197") front end covering a shrink depth capacity of 0 to 240 mm (0 to
9.45"):
0-60 mm (0-2.36") / 60-120 mm (2.36-4.72")/ 120-180 mm (4.72-7.09") /
180-240 mm (7.09-9.45").
Enables the tool shrinking depth setting and ejection of broken tools.
▪
Air cooling cones.
Directs the air stream against the front end of the holder for cooling
▪
Heat-focusing stoppers.
Available for shrinking and unshrinking tool holders Ø3 to Ø32 mm
(Ø0.118" to Ø1.26").
Magnetic insulator that allows the magnetic field to be concentrated on
the front part of the tool holder and to achieve optimised heating.
▪
Split heat-focusing stoppers.
For the split heat-focusing stopper, a locking ring must be ordered.
Split magnetic insulator that allows the magnetic field to be concentrated
on the front part of the tool holder and to achieve optimised heating of
tools with a front end that is larger than shank.
Finned support
Contact bushing
Set of stop rods
Air cooling cone
Standard heat-focusing
stopper
Pair of split heat-focusing
stopper and ring
LOCKING
RING
HALF HEAT-
FOCUSING
STOPPER
7
Advertisement
Table of Contents
