Table of Contents
Advertisement
SHRINK RELEASE
The unshrinking process is the same as the shrinking process.
AUDIBLE FEEDBACK
During operation, the device power source generates an audible feedback tone that changes frequency
depending on the tool holder size and temperature.
It is not unusual to hear the pitch change as the tool holder temperature increases.
Do not be alarmed if you hear this tone, as it is normal.
BOOST MODE
The boost function was made to avoid issues when:
▪ The cutter tool falls outside the H5/H6 tolerance band
▪ There is dirt between tool holder and the tool
▪ Light overheating of the tool holder
▪ Competitor's shrink and unshrink toolholders with same shape as our standard shape, but with different
tolerance on bore
Before using the Boost function, please ensure that your tool holder is not already hot (<30°C (122°F))
Seco is not responsible for misuse of the Boost function.
The Boost function is only for one cycle
1
Push the Mode button until you reach the corresponding mode
shown earlier in the table.
2
Push the Boost button once and the LED of the selected mode will
blink.
3
You are ready to start the heating cycle. Follow the same instruction
from step 9 of the shrinking process.
The Boost function can be configured in the web interface. The default
Boost function increases the heating time by 15%.
22
1
2
Advertisement
Table of Contents
