Setup; Checking The Fluid Levels; Installing The Rollover-Protection System (Rops) - Toro Workman HD 07369 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
Media and Additional Parts
Description
Operator's Manual
Parts Catalog
Operator Training Material
Note: Determine the left and right side of the machine from the normal operating position.
1

Checking the Fluid Levels

No Parts Required
Procedure
1. Check the engine-oil level before and after the engine
is first started; refer to
(page 20).
2. Check the transaxle/hydraulic-fluid level before
the engine is first started; refer to
Transaxle/Hydraulic-Fluid Level (page
3. Check the brake-fluid level before you start the engine
for the first time; refer to
Level (page 24).
Description
No parts required
ROPS frame
Flange-head bolt (1/2 x 1-1/4 inches)
Checking the Engine-Oil Level
Checking the
23).
Checking the Brake-Fluid
Qty.
–
1
6
Qty.
1 Read before operating machine
1 Use to reference part numbers
1 View before operating machine
2
Installing the
Rollover-Protection System
(ROPS)
Parts needed for this procedure:
1 ROPS frame
6 Flange-head bolt (1/2 x 1-1/4 inches)
Procedure
1. Apply medium-grade (service-removable) thread
locking compound to the threads of the 6 flange-head
bolts (1/2 x 1-1/4 inches).
2. Align each side of the ROPS with the mounting holes
on each side of frame of the machine
14
Use
Check the engine oil, the
transaxle/hydraulic fluid, and the
brake-fluid levels.
Mount the Rollover-Protection System
(ROPS).
Use
(Figure 3).