In This Guide - Keysight Technologies UXR Series Hardware Configuration Manual

In This Guide

This guide describes the equipment required to configure MultiScope systems and
shows you how to set up and connect the equipment:
•
Depending on the UXR-Series oscilloscope bandwidths and number of channels
required, you will use one of the configurations shown in the following table.
# of channels # of channels
required (4-ch required (2-ch
oscilloscopes) oscilloscopes)
5-8 3-4
9-20 5-10
Depending on the MXR/EXR-Series oscilloscope bandwidths and number of
channels required, you will use one of the configurations shown in the following
table.
# of channels # of channels
required (8-ch required (4-ch
oscilloscopes) oscilloscopes)
9-16 5-8
After you have set up and connected the MultiScope system, see:
•
See Also
• The Infiniium UXR-Series oscilloscope software's online help for information on
6
Chapter 1, "MultiScope System Requirements," starting on page
Configuration required
2-oscilloscope configuration
3-to-5-oscilloscope
configuration (1 rack)
Configuration required
2-oscilloscope configuration
Chapter 5, "Next Steps," starting on page
using the MultiScope Hosted Instruments software.
See:
Chapter 2, "Two-Oscilloscope System,
UXR-Series," starting on page 11 (that can be
expanded later).
Chapter 3, "Three- to Five-Oscilloscope Systems,
UXR-Series," starting on page 17.
See:
Chapter 4, "Two-Oscilloscope System,
MXR/EXR-Series," starting on page 23 (that can be
expanded later).
27.
Keysight UXR-Series and MXR/EXR-Series MultiScope Hardware
9.