Keysight Technologies UXR Series Hardware Configuration Manual page 4

For example, to set up a four-oscilloscope system, your configuration would
include one N2164A kit (to go from one oscilloscope to two) and two N2165A kits
(to go from two oscilloscopes to three and then from three oscilloscopes to four).
See
MultiScope
To control MultiScope systems and analyze captured data, you can use:
Control Software
• Infiniium oscilloscope software on the Leader oscilloscope. MultiScope
• D9010BSEO Infiniium Offline oscilloscope analysis software on an external host
This software allows time-synchronized acquisitions for multiple-oscilloscope
systems with very low oscilloscope-to-oscilloscope jitter and drift. This software
can be used to configure, capture, and store real-time voltage signals.
Not Included
MultiScope systems also require:
• Equipment rack.
• Rack mount kits (N2156A) for each oscilloscope in the rack.
• Remote interface connection between the system running the MultiScope
4
Figure 1.
software is included as a standard feature.
computer. MultiScope software is included as a standard feature.
control software (either the Leader oscilloscope or an external host computer)
and each oscilloscope in the system (for controlling the individual oscilloscopes
and moving captured data to the host computer).
Ethernet LAN or instrument USB are the most common interface options used.
Keysight UXR-Series and MXR/EXR-Series MultiScope Hardware