Reading Interrupt Source On Receiver Board - Analog Devices EVAL-ADF7023DB Z Series Manual

Reading Interrupt Source on Receiver board

Once the Transmitter has transmitted a packet you should now see "Interrupt Detected!" on the
Receiver software instance.
On the Receiver board the interrupt signifies that a packet has been successfully Received with a valid
CRC.
To check the source of the interrupt, click "Read Source"
To Clear the interrupt status click "Clear All Interrupts"
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Figure 38 point (1))
(
Figure 38
R e v 1 . 1
Figure 38 point (2))
(
Figure 38 point (3))
(
| Page 31