Analog Devices EVAL-ADF7023DB Z Series Manual page 24

Evaluation boards for adf7023 ism band transceiver

Table of Contents

Receiver Board RF Settings

Ensure the First ADF7023 Daughter board is correctly plugged into the First Mother board and that the

"Current_State" is "PHY_ON" on the First instance of the ADF7023 Software.

Refer to Connecting the Evaluation Boards for setup procedures.

Select the "RF Settings" Tab (

Ensure "Packet mode" is selected. (

Set the "RF/Modulation" parameters as required. (

Set the "Receiver" parameters as required. (

If using AFC ensure the AFC pull in range is set to the desired value.

(A value of half the IF bandwidth is recommended.)

Arrow.com.

Downloaded from

Figure 31 point (1))

Figure 31 point (2))

Figure 31 point (3))

Figure 31 point (4))

Figure 31

R e v 1 . 1

| Page 24

Table of Contents

Need help?

Do you have a question about the EVAL-ADF7023DB Z Series and is the answer not in the manual?

Eval-adf7023db2z Eval-adf7023db3z Eval-adf7023db4z Adf7023bcpz