Analog Devices EVAL-ADF7023DB Z Series Manual page 29

Transmitter Board Interrupts
Interrupts may be configured for various conditions in the "Interrupts" tab. (
1. Set the "tx_eof" interrupt. (
This will give an interrupt signal after a packet has been fully transmitted.
2. Write the settings to the device using the "Update Needed" button. (
3. Transmit a packet by clicking "CMD_PHY_TX" (
(Note: Ensure that the current state of the part is in "PHY_ON" before pressing "CMD_PHY_TX".)
"Board 2" is now in Transmit and once a packet is transmitted the part returns to the PHY_ON state.
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Figure 36 point (2))
Figure 36 point (4))
Figure 36
R e v 1 . 1 | Page 29
Figure 36 point (1))
Figure 36 point (3))