Analog Devices EVAL-ADF7023DB Z Series Manual page 25

Receiver Board Rx Packet Settings
Using the Tx/Rx packet tab you can set up the packet format and configure the packet handler. (
1.
2.
3.
4.
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
The transmitted preamble length sync word and CRC can be defined by the user. (
(Note: Ensure CRC is enabled for this test. You have the choice to use the default CRC or enable a
programmable CRC whose polynomial may be set in registers 0x11E and 0x11F.)
Ensure you are using a fixed packet length and that, "Packet Length Max" is set equal the payload length.
( Figure 32 point (3))
Set up the Rx base address. ( Figure 32 point (4))
(Note : This is the start address of the received packet in Packet Ram Memory.)
Write the settings to the device using the "Update Needed" button. (
Figure 32
R e v 1 . 1 | Page 25
Figure 32 point (1))
Figure 32 point (2))
Figure 32 point (5))