Analog Devices EVAL-ADF7023DB Z Series Manual page 11

Connecting the Evaluation Boards
This software can allow TWO evaluation boards to be connected to a single PC. The EVAL board and the software must
be setup accordingly.
Ensure that Switch 4 is in the correct position before connecting to the PC as shown in
•
To set the first board as "BOARD 1" (
•
To set the second board as "BOARD 2" (
Ensure the evaluation mother board with the desired daughter card is connected to the PC via USB cable before running
the software.
Run the ADF7023 software from Start-> Programs->Analog Devices->ADF7xxx->ADF7023.
Once the software is running press Connect USB (
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Figure 14
Figure 15 ) on the Software set the switch shown in Figure 14 to "B1"
Figure 15
Figure 15 ) on the Software set the switch shown in Figure 14 to "B2"
Figure 16 ).
R e v 1 . 1 | Page 11
Figure 14 .