Table of Contents
Advertisement
2. Click the PTZ control buttons to find a position as the initial position of the camera; you can also
call a defined preset and set it as the initial position of the camera.
3. Click Set to save the position.
Call/delete an Initial Position:
You can click
to call the initial position. You can click
the factory default initial position.
4.2.4 Configuring Park Action
Purpose:
This feature allows the camera to start a predefined park action (scan, preset, pattern and etc.)
automatically after a period of inactivity (park time). The park action function only takes effect in
Camera 1.
Note:
Scheduled Tasks function is prior to Park Action function. When these two functions are set at the
same time, only the Scheduled Tasks function takes effect.
Steps:
1. Enter the Park Action settings interface:
Configuration > PTZ > Park Action
2. Check the Enable Park Action checkbox.
3. Set the Park Time as the inactivity time of the camera before it starts the park actions.
4. Choose Action Type from the dropdown list.
User Manual of PanoVu Series Network Camera
PTZ Configuration
Figure 4-9
Set the Park Action
Figure 4-10
to delete the initial position and restore
51
Advertisement
Table of Contents
