Table of Contents
Advertisement
Chapter 5 Storage and Playback
：
Notes
In this and the following chapters, operation of the camera by the web browser will be taken as an
example.
You can set recording and capture schedule for different channels of the camera. Refer to the
actual configuration interface.
5.1 Storage Settings
Before you start:
To configure record settings, make sure that you have the network storage device within the network or
the memory card has been inserted in the corresponding card slot. Refer to the quick start guide for the
location of the memory card slot.
5.1.1 Configuring Net HDD
Before you start:
The network disk should be available within the network and properly configured to store the recorded
files, log files, etc.
Steps:
Add Net HDD
1. Enter the NAS (Network-Attached Storage) settings interface:
Configuration > Storage > Storage Management > Net HDD
2. Input the IP address of the network disk, and input the file path.
3. Select the mounting type. NFS and SMB/CIFS are selectable. You can set the user name and
password to guarantee the security if SMB/CIFS is selected.
Note:
Refer to the NAS User Manual for creating the file path.
For your privacy and to better protect your system against security risks, we strongly recommend
the use of strong passwords for all functions and network devices. The password should be
something of your own choosing (Using a minimum of 8 characters, including at least three of
User Manual of PanoVu Series Network Camera
Select Net HDD Type
Figure 5-1
59
Advertisement
Table of Contents
